32.Home Automation - 06



In this post I'll show you about the I2C OLED display.



This display is use to get the IP address of the control unit.This display comes in many different color combinations.And we need to connect 3.3v to VCC pin & common to the GND pin to operate this display.And we need to connect SDA & SCL pins with the arduino board.

In next post I'll show you about shift registers & how it works.
 

Related Posts:

  • 29.Home Automation - 03 In this post I'll show you about the ESP8622 wi-fi module & how to configure the ESP8622 wifi module.In here we are using the esp-01 version.Wh… Read More
  • 32.Home Automation - 06 In this post I'll show you about the I2C OLED display. This display is use to get the IP address of the control unit.This display comes in m… Read More
  • 31.Home Automation - 05 In this post I'll show you about NRF24L01 RF module & how it works.  This module we are using to connect the main control unit with … Read More
  • 30.Home Automation - 04 As mentioned in the previous post , in this post I'll show you how to upgrade the firmware of the ESP8622 wifi module. To do this first we need… Read More
  • 28.Home Automation - 02 In this post I'll show you about the Arduino Nano board & what it does. This is the brain of this control unit.As above image this modu… Read More

0 comments:

Post a Comment